2020 Bolt EV LT: Reverse camera grid lines not coming on

[RRP]

Hi,
I have a brand new car, 180 miles on the clock. When we start the car and put it in reverse, the camera turns on but the grid lines don't come on even if the option is set in the preferences. I researched it, found a thread on Reddit: I tried resetting the infotainment centre, warming up the car before turning it on, wait a good couple of minutes before shifting the car in reverse. Nothing will turn on the grid lines. If I put the car from reverse to drive, the grid lines come up for a second with the usual button to disable/enable grid lines then the screen goes blank as in should in drive mode.

If I notice the grid lines are missing in R, sometimes just dropping the car in D and then back in R will turn them on but not every time. However, once i see the grid lines in R, they always come on if I go in and out of R.

Has anyone seen this? It seems to be a commonly known issue with the Bolt from what I can see. What is the cause and what can be done about it?

 

[DITLA]

I have a 2023 Bolt (covered 34,500 miles). Just today the reverse guidance grids did not show up on the rearview. It never happened before.
So, when I put my car in reverse, a small box diagram showed on the bottom left of the rearview. I gently touched the top right portion of the box (within the box), and the guidance grids came on. When I touched the same spot again, the guidance grids went off. By mistake, I must have touched it after putting the car in reverse. An easy solution.

 

[voodoomaster]

Hi,
I have a brand new car, 180 miles on the clock. When we start the car and put it in reverse, the camera turns on but the grid lines don't come on even if the option is set in the preferences. I researched it, found a thread on Reddit: I tried resetting the infotainment centre, warming up the car before turning it on, wait a good couple of minutes before shifting the car in reverse. Nothing will turn on the grid lines. If I put the car from reverse to drive, the grid lines come up for a second with the usual button to disable/enable grid lines then the screen goes blank as in should in drive mode.

If I notice the grid lines are missing in R, sometimes just dropping the car in D and then back in R will turn them on but not every time. However, once i see the grid lines in R, they always come on if I go in and out of R.

Has anyone seen this? It seems to be a commonly known issue with the Bolt from what I can see. What is the cause and what can be done about it?

Same issue with my 2121.